One thermostat controls all temperature settings up to 400° F.
Any Hot Melt can be used. No special slugs are required to fill up the Hot Melt chamber. Simply remove the filler cap when the unit is hot, and refill.
Suspension of the unit over a work-bench or on an assembly line is facilitated by the provision of an eyehook, to which a spring balance can be attached. (Optional Extra)
The drip-free dispensing nozzle itself can be changed over to another size in under a minute.
With certain Hot Melts, one trigger pull can provide single runs of up to 25 ft.
7 Cubic inches of Hot Melt can be applied without the need for refilling.
No cleaning is necessary — simply reheat.
As opposed to slug guns, more adhesives can be dispensed at any time as the total hot melt volume is in liquid form.
All prices are in USD
Copyright 2024 Axco Adhesive Systems, All Rights Reserved. |
Sitemap | Facebook | Twitter | YouTube
Nordson® and Slautterback® are registered trademarks of Nordson Corporation and not affiliated with Axco Adhesive Systems, Inc.
HMT® is a registered trademark of Hot Melt Technologies, Inc. and is not affiliated with Axco Adhesive Systems, Inc.
ITW DynatecTM is a trademark of ITW Dynatec, Inc. and is not affiliated with Axco Adhesive Systems, Inc.